Mobotix MX-D25M-SEC-D76 Dokumentacja Pobierz pdf (Strona 95)

95/140

Network and Power Connection

www.mobotix.com • [email protected]

2.9.9 Camera Startup Sequence

As soon as the camera's power supply has been established, the two LEDs will show the

progress of the startup sequence (see

Section5.4.3, «LED Signals and LED Conﬁguration»

in the MOBOTIX

Camera

Software Manual

•

Booting: Immediately after connecting the power supply, the red LED lights up, ﬂashes

for two seconds, then stays on permanently red. A camera self-test is carried out at

this point, and the entire system is started. In case of an error, the camera will start

using the backup system.

• Waiting for key pressed: Both LEDs light up for four seconds. If you press the R or L

key of the camera during this time, the camera will execute the corresponding func-

tion (see

Section 3.2.6, «Starting the Camera with an Automatic IP Address (DHCP)»

and

Section 3.2.5, «Starting the Camera with the Factory IP Address»

). Use a suitable

device to press a key (a ball-point pen, for example).

•

Ready: Once the camera software has been started, the green LED is on permanently

and the red LED blinks. You can now reach the camera via the network using a browser.

Notes

During the startup sequence of the camera, the LEDs will always light up, even if

they have been deactivated in Admin Menu> LED Setup.

LED default settings:

1 Power (on),

Error (ashing)

2 Recording (ashing)

R L

1. Booting

2. Key?

3. Ready

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 139 140

Brak uwag

Mobotix MX-D25M-SEC-D76 Dokumentacja Strona 95