Mobotix MX-KEYPAD1-EXT-SV Informacje Techniczne Pobierz pdf (Strona 104)

104/148

T24 System Manual Part 1: Installation

www.mobotix.com • [email protected]

6. Screw on the ‘door lock unlocked/locked’ door lock switch (coming from the door):

• First wire to IN 2+ terminal

• Second wire to IN - terminal

The device still functions properly if the two wires used

here (operating contact and changeover contact) are

swapped.

Screw on the ‘door opened/closed’ door contact (reed

switch) coming from the door:

• First wire to IN 1+ terminal

• Second wire also to IN - terminal

The device still functions properly if the two wires used

here (operating contact and changeover contact) are

swapped.

Remove the front panel and frame: In order to protect

the board, the board is attached to the front panel

and frame in the original packaging. To continue with

the installation, however, you must ﬁrst separate the

housing and board from the panel and frame. Loosen

the screw in the front panel and lift the panel forwards.

Now remove the attached frame from the board. Please

note that you will need the stainless steel screw in the

front panel again later.

Insert the housing and circuit board into the socket:

The two cable clamps on the rear of the housing are

located at the top. When using a cavity socket, make

sure you only use the stainless steel screws provided.

Using dierent (larger) screws could damage the

board.

Caution

Electrical systems and equipment may only be set up, changed and maintained by a

qualiﬁed electrician or under the management and supervision of a qualiﬁed electrician

in accordance with electrotechnical regulations.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 149 150

Brak uwag

Mobotix MX-KEYPAD1-EXT-SV Informacje Techniczne Strona 104