Mobotix MX-KEYPAD1-EXT-SV Informacje Techniczne Pobierz pdf (Strona 129)

129/148

Installation In The Siedle Vario System

www.mobotix.com • [email protected]

2.9.3 Preparing Network And Power Connections

The door station requires the following basic cabling:

•

(A) Ethernet cable from the PoE switch (or from a router with additional PoE power supply)

• (B) Two wires for powering the Siedle modules from the transformer in the electrical cabinet

• (C) Two wires for the anti-theft protection controller in the electrical cabinet (optional)

• (D) Two wires for the 230 V light relay

• (E) Cables to the external door opener, door contact and door lock switch

Safety Warning

Never connect or handle live cables (for example, a 240 V power supply) on your

own; always have a trained electrician do the installation.

Recommendation For Cabling

As a speciﬁcation for cable line A (network), MOBOTIX recommends using a category 5

(Cat 5) Ethernet installation cable or higher. For cable lines B, C and D, we recommend

laying an 8- or 10-wire YSTY (telephone) cable with 0.8 mm core diameter, even in the

case of smaller installations, to make future expansion more convenient. As a rule, however,

when maximum cable lengths are kept low, YSTY (telephone) cable with only a 0.6 mm

core diameter may also be used. When laying the cable, ensure that sucient length

remains in reserve on the door station end for later extensions or for swapping modules

(lay a cable loop). All two-wire cables should be fed in through a in-wall socket on the

inside of the door with sucient space for cable reserves. Both the network

cable and other cables must be stripped at the ends.

\*+ X 1*/<$ &2

;$2&@'$; ("#

EG _/&+ `+5$#'$+

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 149 150

Brak uwag

Mobotix MX-KEYPAD1-EXT-SV Informacje Techniczne Strona 129